Nokia IP290 - Security Appliance, Руководство по установке

Страница: 35 / 81

Connecting Network Interfaces
Nokia IP290 Security Platform Installation Guide 35
Note
For information about using the boot manager, see the Nokia IPSO Boot Manager
Reference Guide .
After some miscellaneous output, the following prompt appears:
Hostname?
If the Hostname? prompt does not appear on the console, check the console port and console
display connections to ensure that the serial cable is completely plugged in at both ends. If
you verify the console connections and still do not see either the BOOTMGR> or
Hostname? prompts, verify that the terminal or terminal emulator program settings are
correct. If the settings are correct, contact your Nokia service provider as listed in
“Nokia
Contact Information” on page 3.
3.
Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
starting.
If the DHCP client starts, it might configure the appliance with an incorrect host name and
IP address (this could happen if a DHCP server on your network is configured to respond to
any request). To reset the incorrect host name and IP address:
a. Establish a console connection to the appliance.
b. Log into the system using the user name admin and the password password.
c. Enter the following:
rm /config/active
or
mv /config/active /config/active.old
d. Reboot the appliance.
e. Respond to the Hostname? prompt within 30 seconds to prevent the DHCP client from
restarting.
4. At each subsequent prompt, type the requested configuration information and then press
Enter.
For more information about how to respond to the prompts during the initial configuration
process, see the
Getting Started Guide and Release Notes for the version of Nokia IPSO you
are using.
5. After you complete the initial configuration, you can use Network Voyager to configure the
remaining network ports.
Connecting Network Interfaces
Connect at least one network interface to the network to use as the Nokia Network Voyager
system-management interface.