Nokia IP290 - Security Appliance, Руководство по установке

Страница: 46 / 81

5
Installing and Replacing Network Interface Cards
46 Nokia IP290 Security Platform Installation Guide
If you do not deactivate the interfaces before removing the NIC, you may have to reinstall the
NIC to deactivate its logical and physical interfaces in Network Voyager.
For information about how to access Network Voyager, see
“Using Nokia Network Voyager” on
page 36.
Installing NICs
Note
Before removing a configured network interface card with these instructions, you must
deactivate the NIC by using Nokia Network Voyager. For additional information, see
“Deactivating Configured Interfaces” on page 45.
Use these instructions to install a NIC in the IP290 appliance. Some steps are not applicable to
all procedures. The instructions point out steps appropriate to each procedure.
Before You Begin
To install a Nokia NIC, you need the following:
„
A Phillips-head screwdriver
„
Physical access to the appliance
„
Access to the appliance by using Nokia Network Voyager or the CLI
„
A suitable, grounded work surface
„
A field replaceable unit kit, including the NIC
Note
You do not need to manually disconnect power for this procedure. Any servicing of the
appliance should be completed with the chassis tray assembly fully removed from the
appliance.
To install a network interface card
1.
Use Nokia Network Voyager or command-line interface (CLI) to perform an orderly
shutdown of the IP290 appliance.
For information about how to access Network Voyager and the related reference materials,
see
“Using Nokia Network Voyager” on page 36.
2. Turn off the power to the IP290 appliance.
3. Remove the power cord.