8
Configuring the device
There is usually no need to configure the device since most of the settings are already at their best
defaults. However, if you want to see what kind of settings there are or edit settings, use MekuWin
program and DCS772 (USB-POL converter). You can download MekuWin from Nokeval’s web site
www.nokeval.com for free.
Connection settings
Communication settings for configuration:
baud rate 9600
protocol SCL
address 0
Programming connector
The device has a 3PIN POL programming connector under the backup battery compartment lid.
Remove the battery compartment lid to access the programming connector. Use POL-3PIN adaptor to
connect the DCS772 to the device. The 3PIN POL programming connector can be connected in both
ways.
Conf menu
The configuration menu settings are explained in the following chapters.
Mon menu
The monitor menu settings are mainly for manufacturer use, and most of them are not explained in this
manual. Support for purpose of these settings is available upon request from [email protected]
Cal menu
The calibration menu settings are only for manufacturer use, and they are not explained in this manual.
