MAINTENANCE
44
SpeedScrub Rider 331140 (9- 2013)
REPLACING SIDE SQUEEGEE BLADES
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
1. Open the side squeegee.
2. Pull the old side squeegee blade from the
side squeegee retainer. Slide the new blade
onto the retainer.
3. Close the side squeegee.
ADJUSTING THE SQUEEGEE GUIDE ROLLER
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
The squeegee guide rollers are located on both
ends of the rear squeegee. The rollers guide the
squeegee blade end along a wall. Loosen the nut
located at the top of the guide roller and move the
roller in or out to adjust how close the end of the
squeegee blade is to the wall. The squeegee
blade end should be further away from the wall
when the floor curves up into the wall.
LEVELING THE REAR SQUEEGEE
Leveling of the squeegee assures the entire
length of the squeegee is in even contact with the
surface being scrubbed. Perform this adjustment
on an even and level floor.
1. Lower the squeegee and drive the machine
forward a few feet.
2. Turn off the machine
ON/OFF key switch
.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off
machine, and remove key.
3. Look at the deflection of the squeegee over
the full length of the squeegee blade.
4. If the deflection is not the same over the full
length of the blade, turn the squeegee
leveling bolt to make adjustments.
The squeegee leveling bolt is located directly
behind the squeegee suction hose.
DO NOT
disconnect the suction hose from the
squeegee frame when leveling squeegee.
Turn the squeegee leveling bolt
counter-clockwise to increase the deflection at
the ends of the squeegee.
Turn the squeegee leveling bolt clockwise to
decrease the deflection at the ends of the
squeegee blade.
5. Drive the machine forward with the squeegee
down to recheck the squeegee blade
deflection if adjustments were made.
6. Readjust the squeegee blade deflection if
necessary.
