SS300 Service Information (3-2017)
35
MAINTENANCE
FOR SAFETY: When loading/unloading machine
onto/off truck or trailer, use a ramp that can
support the machine weight and operator.
FOR SAFETY: Do not operate the machine on a
ramp incline that exceeds a 21% grade level.
Fig. 121
3. Once loaded, position the front of the machine up
against the front of the trailer or truck. Lower the
scrub head, turn key off and set parking brake, if
equipped (Figure 131).
4. Place a block behind each wheel (Figure 131).
5. Using tie-down straps, secure the machine using
the four tie-down brackets located on the machine
frame (Figure 131). It may be necessary to install
tie-down brackets to the floor of your trailer or
truck.
ATTENTION: Do not use control console area or
accessory storage rails for tie-down locations,
damage may occur.
Fig. 122
STORING MACHINE
The following steps should be taken when storing the
machine for extended periods of time.
1. Charge the batteries before storing machine to
prolong the life of the batteries. Recharge batteries
every 3 months.
2. Drain and rinse recovery tank and solution tank.
3. Store the machine in a dry area with squeegee
and
scrub head in the up position.
ATTENTION: Do not expose machine to rain, store
indoors.
4. 4. Open the recovery tank lid to promote
air
circulation.
NOTE: To prevent potential machine damage
storemachine in a rodent and insect free environment.
FREEZE PROTECTION
Storing machine in freezing temperatures.
1. Completely drain solution tank and recovery tank.
2.
Empty the water from the solution tank filter
located under machine. Replace filter.
3. Pour 1 gallon / 4 liters of propylene glycol based
recreational vehicle (RV) antifreeze into the
solution tank.
Models equipped with optional Severe Environment
detergent tank - Lift out the tank and empty the
detergent from tank. Pour a 1/4 gallon / 1 liter of
propylene glycol based recreational vehicle (RV)
antifreeze into the detergent tank.
4.
Turn machine on and operate the solution flow
system. Turn the machine off when the antifreeze
is visible on floor.
Models equipped with ec-H2O option - Operate
ec-
H2O scrubbing to cycle antifreeze through system.
Models equipped with Severe Environment mode op-
tion - Press the Severe Environment button to cycle
antifreeze through system.
5. After storing machine in freezing temperatures,
drain any remaining antifreeze from the solution
tank and from the optional Severe Environment
detergent tank. Add clean water to solution tank
and to optional detergent tank and operate the
machine to flush system.
