19
3.4. Repeat actions pointed in items 2.5, 2.5.1 and 2.5.3 for proper components insertion into the PCB
and soldering.
4. Low and High Voltage sources operability test
After Low and High Voltage sources components assembly it is necessary to check relevant source
proper operability.
4.1. Select multi-meter DC 200 V measuring range.
4.2. Identify the test ground (GND), 5V and HV test points as shown below.
4.3. Plug in the power supply, and then test HV source operability using a multi-meter in DC voltmeter
mode. Touch the black probe on the GND test point and the red probe on the 165 V test point. The
voltage should measure between 160 and 175 Volts. When PCB is powered its HV source contacts
shall be not touched by hands or non-isolated tools (non-isolated tweezers for example). If not,
disconnect power and remember that the HV source output could still hold charge at 165-175 V.
Check all relevant joints quality and polarity.
Do not continue with the next test until the error in HV source exists.
Содержание IN-8-2
Страница 9: ...9 nixiediy gmail com Transistors BC547 Q5 Q6 BC557 Q1 MPSA42 Q7 IRF840 MOSFET Q2 EL817 OK1 OK6...
Страница 10: ...10 nixiediy gmail com Diodes 1N4004 D1 UF4004 D3 1N914 D2 LED 3mm LED1 LED6...
Страница 11: ...11 nixiediy gmail com Integrated Circuits LM7805 U1 MC34063 U2 K155 1 U3 ATMEGA328P PU U4 DS3231 U5...