background image

MODEL# 71042WM

Printed in China

INSTRUCTIONS & WARRANTY

ONE-YEAR LIMITED WARRANTY

NYL Holdings LLC warrants the original consumer purchaser of 

this product that it shall be free of defects in materials and 

workmanship for one year from the purchase date of this product. 

Defects caused by tampering, improper use, unauthorized 

modifications or repairs, immersion in water or abuse are not 

covered by this warranty. If a defect covered by this warranty 

occurs during the warranty period, package your clock carefully 

and send it to:

Att: Repair center / NYL Holdings LLC

99 West Hawthorne Ave. Suite 202

Valley Stream, NY 11580

(516) 256-3240

1-877-378-7154 

You must include a Proof of Purchase, either the original receipt or 

a photocopy and a check or money order for USD $5.95 to cover 

the cost of shipping and handling. Also include your return address 

inside the package . NYL Holdings LLC will repair or replace the 

clock and return it to you. NYL Holdings LLC will not be liable for 

any loss or damages, including incidental or consequential 

damages of any kind: from any breach of warranty either 

expressed or implied relating to the product. Since some states do 

not allow the exclusion or limitation of incidental or consequential 

damages, these limitations may not apply to you. This warranty 

gives you specific legal rights, and you may have other rights that 

vary from state to state.

FCC Remarks

Changes or modifications not expressly approved by the party 

responsible for compliance could void the user’s authority to 

operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is 

subject to the following two conditions: (1) This device may not 

cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause 

undesired operation.

     This equipment has been tested and found to comply with the 

limits for a Class B digital device, pursuant to Part 15 of the FCC 

Rules. These limits are designed to provide reasonable protection 

against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communica-

tions. However, there is no guarantee that interference will not 

occur in a particular installation.

If this equipment does cause harmful interference to radio or 

television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different  

  from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician.

FCC RF Radiation Exposure Statement Caution: To maintain 

compliance with the FCC’s RF exposure guidelines, place the product

at least 20cm from nearby persons.

BATTERY BACKUP

(OPTIONAL)

#1 Remove the battery cover on the bottom 

of the clock.

#2 Insert 2 fresh AAA battery. 

Make sure to follow the +/- symbols.

#3 Replace the battery cover.

Note:

 The battery backup feature is not necessary to operate your digital 

alarm clock. It is optional to have the battery backup in case of a power 

outage. In the event of a power failure, the battery backup will automatically 

continue to operate the clock and maintain time and alarm time. When the 

clock runs on the battery backup the clock may lose or gain a few minutes 

per hour. This may require resetting the time for precise timekeeping.

IMPORTANT: 

Extended storage can cause batteries to leak and damage 

the unit. Leaky batteries should be discarded immediately. Skin burns or 

other personal injury can result. Always dispose of batteries according to 

federal, state and local regulations.

IMPORTANT:

- Clean the battery contacts and also those of the device prior to battery 

  installation.

- Remove the battery from the equipment which is not to be used for an  

  extended period of time.

- Remove used battery promptly

CAUTION:

 RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN 

INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO 

THE INSTRUCTIONS. SHALL BE MARKED CLOSE TO THE BATTERY

COMPARTMENT OR A STATEMENT IN THE USER MANUAL
  

GETTING STARTED

Plug the power adapter 

into the back of the 

clock. Then plug the 

other end into a standard 

electrical outlet.

POWER

RADIO / BLUETOOTH

TIME / PRESET

PLAY / PAUSE

HOUR / << TUNE

MINUTE / TUNE >>

ALARM 2 /

SNOOZE / SLEEP

BLUETOOTH ON

ALARM 2

ON INDICATORS

(RADIO / BUZZER)

ALARM 1

ON INDICATORS

(RADIO / BUZZER)

PM INDICATOR

ALARM 1 / VOLUME -

Reviews: