www.nitronic.ch
-
11 -
Nitronic AG
Mattenstrasse 11
CH – 2555 Bruegg
Tel.
+41 32 373 7070
Switzerland
Fax
+41 32 373 70
75
Set up
Check the set mains voltage on the unit and change if necessary following the
instructions on page 12.
•
Place the ST730
T
onto a firm and level bench.
•
Remove the safety cover (2) by removing screws (3)
(Fig. 2).
•
Remove the foam (1) between the jaws (4) and the stripping head (5).
•
Replace the safety cover (2) and fasten screws (3)
(Fig. 2).
•
Place the ST730
T
on a bench so that its front edge is
flush with the edge of the bench. This way the stripping
debris can fall into a waste basket.
•
Plug in the power cord.
•
Turn on the ST730
T
with the main switch (A) (Fig.
4).
Fig. 2. Remove protective foam
Fig. 3. Remove safety cover / place
machine in position
Fig. 4. Toggle main switch (A) to I
