Nilfisk-Advance SC3000, Руководство по обслуживанию

Страница: 9 / 130

General Information 9 Service Manual – SC3000
− The machine working temperature must be between 0 °C and +40 °C.
− The machine storage temperature must be between 0 °C and +40 °C.
− The humidity must be between 30% and 95%.
− When using floor cleaning detergents, follow the instructions on the labels of the detergent
bottles.
− To handle floor cleaning detergents, wear suitable gloves and protections.
− Do not use the machine as a means of transport.
− Do not allow the brushes to operate while the machine is stationary to avoid damaging the floor.
− In case of fire, use a powder fire extinguisher, not a water one.
− Do not tamper with the machine safety guards and follow the ordinary maintenance instructions
scrupulously.
− Do not allow any object to enter into the openings. Do not use the machine if the openings are
clogged. Always keep the openings free from dust, hairs and any other foreign material which
could reduce the air flow.
− Do not remove or modify the plates affixed to the machine.
− To manually move the machine, the electromagnetic brake must be disengaged. After moving the
machine manually, engage the electromagnetic brake again. Do not use the machine when the
electromagnetic brake handwheel is screwed down.
− When the machine is to be pushed for service reasons (missing or discharged batteries, etc.), the
speed must not exceed 4 km/h.
− This machine cannot be used on roads or public streets.
− Pay attention during machine transportation when temperature is below freezing point. The
water in the recovery tank or in the hoses could freeze and seriously damage the machine.
− Use brushes and pads supplied with the machine and those specified in the User Manual. Using
other brushes or pads could reduce safety.
− In case of machine malfunctions, ensure that these are not due to lack of maintenance. Other -
wise, request assistance from the authorised personnel or from an authorised Service Center.
− If parts must be replaced, require ORIGINAL spare parts from an Authorised Dealer or Retailer.
− To ensure machine proper and safe operation, the scheduled maintenance shown in the relevant
chapter of this Manual, must be performed by the authorised personnel or by an authorised Ser -
vice Center.
− Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
− When WET batteries are installed on the machine, do not tilt the machine for more than 30°
from the horizontal plane to prevent the highly corrosive acid from leaking out of the batteries. If
the machine must be tilted to perform any maintenance procedure, remove the batteries.
− The machine must be disposed of properly, because of the presence of toxic-harmful materi -
als (batteries, etc.), which are subject to standards that require disposal in special centres (see
Scrapping chapter).