Nilfisk-Advance SC3000, Руководство по обслуживанию

Страница: 108 / 130

Squeegee System 108 Service Manual – SC3000
Squeegee blade check and replacement
Note: The squeegee must be clean and its blades must be in good condition in order to get a
good drying.
Warning! It is advisable to wear protective gloves when cleaning the squeegee because there
may be sharp debris.
1. Clean the squeegee as shown in the previous
paragraph.
2. Check that the edge (E) of the front blade (C)
and the edge (F) of the rear blade (D) lay down
on the same level, along their length; otherwise
adjust their height according to the following
procedure:
◦ Remove the tie rod (G), disengage the fas-
tener (M) and adjust the rear blade (D); then
engage the fastener and install the tie rod.
◦ Loosen the handwheels (I) and adjust the
front blade (C); then tighten the handwheels.
3. Check the front blade (C) and rear blade (D) for
integrity, cuts and tears; if necessary replace
them as shown below. Check the front corner (J)
of the rear blade for wear; if necessary, overturn
the blade to replace the worn corner with an
integral one.
If the other corners are worn too, replace the
blade according to the following procedure:
◦ Remove the tie rod (G), disengage the fas-
tener (M) and remove the retaining strip (K),
then replace/overturn the rear blade (D).
◦ Install the blade in the reverse order of re-
moval.
◦ Unscrew the handwheels (I) and remove the
retaining strip (L), then replace the front
blade (C).
◦ Install the blade in the reverse order of re-
moval.
4. After the blade replacement (or overturning),
adjust the height as shown in the previous step.
5. Connect the vacuum hose to the squeegee.
6. Install the squeegee and screw down the
handwheels.
7. If necessary, adjust the squeegee balance
adjusting handwheel.
C
D
I
K
F
J E
D
C
L
I
M
G
I
P100583