Nilfisk-Advance SC3000, Руководство по обслуживанию

Страница: 48 / 130

Electrical System 48 Service Manual – SC3000
Delta-Q IC 650 Charge Profile Selection
Set the DELTA-Q on-board charger according to the type of batteries installed as shown below:
7. Disconnect AC input (A) from the charger, or from the wall outlet. Wait 30 seconds for the input relay to
open.
D
E
F C
P100396
8. While reconnecting AC input (B), press and hold the
Select Charge Profile Button (C). Hold the button until
Error Indicator (D) is on and Amber in color and Battery
Charging Indicator (E) starts flashing Green.
Note: You will have to hold the button for 15-
20 seconds for this to occur.
9. Press and release the Select Charge Profile Button (C) to
advance through charging profiles loaded on the charger.
The selected charging profile will be displayed (F) up to
three times (e.g. “P-0-1-1” for Profile 11).
Note: See the BATTERY CHARGER PROFILE
SELECTION CHART in the next page
for the relevant profile. Process will time
out and profile will remain unchanged if
there is 15 seconds of inactivity, a profile
number is allowed to display three times,
or if AC power is cycled.
10. Once desired charging profile is displayed, press and hold
button (C) for 10 seconds to confirm selection and exit
Profile Selection Mode.
Note: Make sure both the Error Indicator and
the Battery Charging Indicator are no
longer illuminated before releasing the
button.
11. Press the Select Charge Profile Button (C) to check that
the desired profile is selected.
B
A