A - 38
Nilfisk Liberty SC50 - 56091204
12/2017
INSTRUCTIONS FOR USE
A - ENGLISH
6/2020
RECORDING COPYCAT™ PLANS
1 Press Record Switch
(U)
.
a. Highlight “Copycat” from menu.
b. Press Record Switch
(U)
to start recording.
c. Press One-Touch Scrub Switch
(M)
to turn scrubbing on/off where needed
in the plan. While recording, the scrub settings can be adjusted as
desired.
d. Begin to drive the machine along the plan route.
e. LED Status Bar
(4)
will emit a slow flashing green light.
2 Clean the area using the desired vacuum, solution, scrub and detergent
settings.
- While recording CopyCat;
a. Operate all of the scrub functions. Clean the floor as if in manual
mode. See section “OPERATING THE MACHINE MANUAL
MODE” for more information on adjusting any of the scrub settings.
The machine will record every action of the operator including
adjustments to scrub settings, use of the horn and remember the
route traveled
See Figure 3-2. NOTE:
Horn will only be recorded
if it’s pressed while the machine is moving. Horn is not recorded if
pressed while the machine is stopped. The machine will not record a
full stop made by the operator while recording.
b. The reverse switch is not selectable while recording.
\ cancel, £ record
Fill-In
Copycat
RECORD PLAN
Select:
fi finish, ff scrub on/off
Turn scrubbing
ON/OFF where needed
RECORDING
M
A
B
C
D
E
F
V
W1
U
T
S1
FIGURE 3-2
A Map Area
B Plan Start Point
C Plan Start Area
D Plan Route
E Permanent Obstacle
F Plan Stop Point
