This document may be subject to change
Side 11 of 24
Heating surface
The unit can be equipped with a heating surface.
It is possible to retrofit a heating surface. The surface must be activated in the CTS 602 control in
order to function together with the unit and for the frost-protection to be active.
When installing a heating surface T7 is the temperature sensor in the inlet.
Use of the CTS600 panel:
- press ESC to go one step back in the menu
- press
p
to move up or down in a menu or to adjust an
activated menu
- press ENTER to activate a menu
- press ENTER to confirm a menu
- press OFF to turn off the unit
- press ON to turn the unit on
SERVICE
ENTER
DEFROST
INLET
CONTROL
TEMP.
CONTROL
PRESET
OFF
RESTART
OFF
ROOM
CONTROL
AIR
EXCHANGE
INLET
HEATING
AIR
QUALITY
MANUAL
OFF
MODBUS
ADR 30
DATALOG
INTV 10
Forsinkelse fra
opstart af blæsere
og varmekrav til
eftervarmefladen
frigives (0 – 60
min.)
”OFF”
0 MIN
”EL SUP”
ENTER
SELECT
VANDSUP
0–10 V
”PERIOD”
”0–10 V”
”0/5/10 V”
VALG
OFF
ENTER
ENTER
FORSINK
0 MIN
0–10 V
”EL SUP”
Pulserende med
1 min. periode
Trinløs analog
10 V ON/OFF
1 min. periode
HEAT
SURFACE
Should be chosen
when installing a
heating surface for
water.
Controlled via 0 -10
V signal
Should be chosen
when installing an
electrical heating
surface, controlled
via 0-10 V signal
DELAY
SELECT
SELECT
SELECT
The setting ”OFF”
is chosen for
systems without
heating element
SELECT
”WATERSUP”
SELECT
SELECT
SELECT
SELECT
SELECT
”PERIOD”
”0–10 V”
”0/5/10 V”
Pulserende med
1 min. periode
Trinløs analog
10 V ON/OFF
1 min. periode
SELECT
SELECT
SELECT
Figure 8: The “Central heating” menu
