![background image](http://html1.mh-extra.com/html/niko/10-850/10-850_manual_1689562053.webp)
10-850
53
nv
Niko
sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: [email protected] — www.niko.eu EN
5.3. Assigning the telephone address to the sensor input
Upon delivery, the sensor input is programmed to telephone address 10.
If you would like to have the same telephone ring via the sensor input as rings via a bell push button on the external unit, then program the same
telephone address for both.
Assigning the telephone address to the sensor input
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
11 XX
✱
where:
- XX = telephone address
You have assigned a telephone address to the sensor input.
3.
Exit the programming mode.
5.4. Assigning a call number to a telephone address
In order to call the correct number when a telephone address is called, you must program one call number per telephone address on the telephone
interface.
Telephone address 10 is used for the sensor input. You can also program a call number on this address so that, for example, a floor call is possible.
Assigning a call number to a telephone address
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
12 XX YY…Y
✱
where:
- XX = telephone address (depending on the variant)
- YY…Y = call number (maximum of 16 numbers)
You have assigned a call number to a telephone address.
3.
To check whether there is memory free, enter the following key
combination:
13 XX
✱
where:
- XX = telephone address
You will hear a positive function tone if the telephone address is
in use.
You will hear a negative function tone if the telephone address is
still free.
4.
Exit the programming mode.
5.5. Activating the sensor input function
You have just set up the device that must ring via the sensor input (see sections 5.3. and 5.4.).
Activating the call function
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
24 0
✱
You have activated the call function of the sensor input.
3.
Exit the programming mode.
You can also use the sensor input to open a door lock.