10-850
51
nv
Niko
sa Industriepark West 40, BE-9100 Sint-Niklaas, Belgium — tel. +32 3 778 90 00 — fax +32 3 777 71 20 — e-mail: [email protected] — www.niko.eu EN
Changing the number of ring tones
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
16 X
✱
where:
- X = number from 0 to 9 (0 = 10 ring tones, 1 = 1 ring tone, 2 =
2 ring tones …)
You have changed the number of ring tones.
3.
Exit the programming mode.
5. SETTINGS
5.1. Setting the telephone interface variant
Upon delivery, the telephone interface contains a call list of 16 call numbers (X = 1).
You can change the telephone interface to a variant with 4, 32 or 64 call numbers.
Setting the telephone interface variant
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
46 X
✱
where:
- X = 0 (4 oproepnummers), 1 (16 oproepnummers), 2 (32
oproepnummers) of 3 (64 oproepnummers)
Je hebt het aantal oproepnummers van de telefooninterface
gewijzigd.
3.
Exit the programming mode.
5.2. Changing the telephone interface number
Upon delivery, the telephone interface number is set to 72, which corresponds to 16 call numbers.
You can change this interface number, depending on the number of call numbers that you want to use in the installation (see overview table below).
If you use several telephone interfaces with the same variant in one installation, you must change the interface number of each extra telephone
interface.
Attention:
If you change the telephone interface number after you have assigned the bell push buttons (see section 5.6.), the interface will not react
when you press these bell push buttons. In that case, you must erase the bell push buttons and reprogram them with the new serial number.
Changing the telephone interface number
Step
Action
Result
1.
Activate programming mode.
2.
Enter the key combination:
18 XX
✱
where:
- XX = number between 10 and 72
You have changed the telephone interface number.
3.
Exit the programming mode.
