Nice HSTS2, Инструкции и предупреждения по установке и использованию

Страница: 11 / 94

English – 9
EN
tion) and the actual execution of the commands of all the automation units
associated with the scenario.
04. Confirm with “ OK ”.
The icons associated with the scenarios just created will be available in the
main screen “ Scenarios ”.
4.9 - Editing or deleting a scenario
01. In the submenu “ Scenarios ” , touch and select the scenario;
02. To edit select “ Edit ” then resume from paragraph 4.8 - point 03;
03. To delete, select “ Delete ” then confirm by selecting “ YES ” and pressing
“ OK ”.
4.10 - Disabling a command in a scenario
01. Turn on the touch screen keypad, touch the icon and then the icon
in the main screen;
02. Touch , the scenario you wish to edit and then “ Edit ”;
03. In the appearing screen, touch “ Commands ”;
04. Touch the automation unit you wish to disable and select the empty box
( ---- );
05. Confirm with “ OK ”.
4.11 - Running a scenario
01. Turn on the touch screen keypad, touch the icon and then the icon
in the main screen;
02. Touch the icon of the scenario you wish to run.
If the scenario envisages the arming/disarming of an alarm, you will be asked
to enter the access code.
4.12 - Programming the 4 shortcut keys
Each of the 4 shortcut keys ( fig. 2-h ) can be associated with a desired com-
mand out of those created.
01.
Turn on the touch screen keypad, touch the icon and the icon “
Auto-
mations ”
in the main screen;
02. Scroll through the icons using the scroll bar to the side;
03. Touch and then “ Shortcut keys
”;
04. Select the key to be configured ( fig. 13 );
05.
In the next screen touch:
“ Type ” to select None, Scenario, Group or Automation Unit.
“ Name ” to select the command/
automation in the list of scenar-
ios, group or automation units,
respectively.
“
Command
” to select the spe-
cific command to be sent (not
available if a scenario had been
selected previously) .
06. Confirm with “ OK ”.
Repeat the procedure to create the
other keys.
To edit, select the key once again and resume the configuration as stated
above.
To delete, select the key and in the “
Type ” function, set “ ---- ”.
4.13 - Reset
Resynchronises the touchscreen with all the stored radio devices.
Warning - Operation to be performed only in case of radio communication
anomalies.
01. Press the “ Reset ” button for 6 seconds;
02. Confirm with YES to complete or NO to exit.
4.14 - Executing automation units in automatic mode
Up to 10 timers can be configured to command automation units, scenarios
and groups automatically ( fig. 14 ).
For the configuration, follow the steps below:
01. Turn on the touch screen keypad, touch the icon , scroll down and
select the icon
in the main screen;
02.
Select a timer in the list.
In the screen ( fig. 14 ), touch:
“ Name ” to write the name associated with the automatic execution;
“
Enabled
” to enable the automation unit execution;
“ Event ” to configure the automation, the scenario or the group to be com-
manded.
13