4.Measurement
NIC-TD-0000025-00
- 14
–
4.2.3.
Checking the probe connection
Sample gases to be measured are fed into the equipment from the probe through the
sample inlet. The tip of the probe is provided with a filter to protect it from dust. A
measurement being made without the probe connected could result in fine particles entering
the equipment, which could then result in the measured values being scattered and in the
worst case damage to the equipment.
Select the appropriate probe in accordance with the measurement place before starting a
measurement.
4.2.4.
Confirming the equipment usage conditions
The equipment usage conditions will vary depending on the measurement mode used.
Conduct measurements with the usage appropriate to the measurement mode.
＜
EMP-2
＞
(1)
Normal mode
/ One Minute mode
Operators can carry and measure with the equipment fitted on their shoulder or
around their waist.
Ensure to carry out measurements with the equipment parallel to the ground.
<Example of Normal mode use>
