13
RCU 11
Starting
Starting
General
The RCU has a preset IP address: 10.200.1.1.
NOTE!
Images and settings on the following pages may
show some difference, depending on the browser, settings
and the version of the RCU, as well as the heat pump con-
figuration.
RCU configuration software
The RCU configuration software is a PC-based program
that can be used to prepare different network parameters
in the RCU. The program can search for RCU units on an
Ethernet network, after which the IP address, network
mask, gateway, DNS, etc. can be set. DHCP can also be
activated in the unit.
Install by running the installation program Setup-
NetBiterConfig.exe that is on the supplied CD.
System requirements
Pentium 133 MHz
•
5 MB free hard disk space
•
Windows 95/98/ME/NT/2000/XP
•
Network card (Ethernet)
•
If a different operating system than Windows is used the
configuration software can not be used. Then connect to
the RCU’s preset IP address in the web browser and use the
web interface to change the network settings. See section
“Starting” – “Logging in”.
Search for connected units
When the program starts, it will automatically search for
an RCU network connection. A list will be displayed of all
units that are found. A new search can be made by pres-
sing the “Scan” button.
A DHCP server can be started under Advanced options
(only active when Netbiter Config is running). Use this al-
ternative to find an RCU which is unintentionally set to use
DHCP in a network where DHCP servers are missing.
IP:
IP address for the RCU
SN:
Network mask
GW:
Gateway
DHCP:
Dynamically assigned IP address (On/Off)
Version:
Software version
Type:
Product type
MAC:
Ethernet MAC address
