NF DF 1906, Инструкция по эксплуатации

Страница: 54 / 96

5.2 Command List
DF1906
5-4
Table 5-2 Common Commands
Common Command
and Quer y
Name Function
*CLS Clear Status Command Clears the standard event status register.
*ESE Standard Event Status Enable
Command Sets the standard event status enable
register.
*ESE? Standard Event Status Enable
Query Quer ies the setting of the standard event
status enable register.
*ESR? Standard Event Status Register
Query Quer ies the standard event status res ister.
*IDN? Identif ication Query Quer ies the ID information of the device.
*OPC Operation Complete Command Gener ates the operation complete
message (OPC) of the standard event
status register when the device operation
is complete.
* This equipment does not gener ate the
OPC message. ( Always 0)
*OPC? Operation Complete Query Returns 1 when the device operation is
complete.
* This equipment always returns 0.
*RST Reset Command Executes device reset.
* This equipment performs the same
process as the setting memory
initialization.
*SRE Service Request Enable Command Sets the service request enable res ister.
*SRE? Service Request Enable Query Quer ies the setting of the service request
enable resister.
*STB? Read Status Byte Query Quer ies the status byte and master
summary status bit.
*TRG Trigger Command Command to apply a trigger, which does
not do anything in this equipment. ( An
error does not occur.) To set a trigger, use
the TRIGger subsystem command.
*TST Self Test Query Executes the self test of the device and
returns the result.
* This equipment always returns 0.
*WAI Wait to Continue Command Puts the equipment into the wait state
until all commands and quer ies that have
been received befor e are f inished.
* This equipment does not do anything.
(An error does not occur, either.)
*RCL Recall Command Reads the content of the spec if ied setting
memory.