NF BP4620, Инструкция по эксплуатации

Страница: 93 / 214

4.5 Sequence Operation
BP4620
4-46
4.5.6 Sequence operation setting example
The procedure for newly setting a sequence operation, taking as an example the sequence shown in
Figure 4-20, is described below.
Figure 4-20. Sequence Transition Example (in CV-INT Mode)
Table 4-19. PROGRAM Setting List
Step No. 1 2 3 4 5 6
Step time (TIME) 0.1 0.2 0.1 0.2 0.2 0.3
DC voltage (DC VOLT) 2.50 7.50 7.50 5.00 10.00 0.00
DC voltage operation type SWEEP KEEP CONST SWEEP SWEEP SWEEP
Step termination (STEP TERM) CONT CONT CONT CONT CONT STOP
Jump step (JUMP STEP) 0 0 0 2 0 0
Jump count (JUMP NUM) 1 1 1 1 1 1
Branch 0 (BRANCH0) 0 0 0 0 6 0
Though the DC voltage of step 2 is set to 7.50 V, the output DC voltage will be 2.5 V which is
succeeded from the previous step (step 1) because the DC operation type of step 2 is set to KEEP. After
executing step 4, the sequence will jump to step 2 because the jump step of step 4 is set to 2 (<1> in
Figure 4-20). The output DC voltage will be kept to 5 V coming from the previous step (step 4) because
the DC operation type of step 2 is set to KEEP. The jump times of step 4 is set to 1, so the sequence will
move to the next step (= step 5) after jumping once and executing step 4 (<2> in Figure 4-20). The step
time of step 5 is set to 0.2 s and the branch 0 jump step of step 5 is set to step 6, so the sequence will
immediately move to step 6 when the branch 0 is input within the step time (<3> in Figure 4-20).