Newport i16-AL, Руководство оператора

Страница: 16 / 48

12
3.1 Introduction (continued)
Table 3.1 Button Function in Configuration Mode
a
(MENU)
• To enter the Menu, the user must first press
a
button.
• Use this button to advance/navigate to the next menu item.
The user can navigate through all the top level menus by
pressing
a
.
• While a parameter is being modified, press
a
to escape
without saving the parameter.
b
(UP)
• Press the up
b
button to scroll through “flashing” selections.
When a numerical value is displayed press this key to increase
value of a parameter that is currently being modified.
• Holding the
b
button down for approximately 3 seconds will
speed up the rate at which the set point value increments.
• In the Run Mode press
b
causes the display to flash the PEAK
value – press again to return to the Run Mode.
c
(DOWN)
• Press the down
c
button to go back to a previous Top Level
Menu item.
• Press this button twice to reset the device to the Run Mode.
• When a numerical value is flashing (except set point value) press
c
to scroll digits from left to right allowing the user to select the desired
digit to modify.
• When a setpoint value is displayed press
c
to decrease value of a
setpoint that is currently being modified. Holding the
c
button
down for approximately 3 seconds will speed up the rate at which
the setpoint value is decremented.
• In the Run Mode press
c
causes the display to flash the VALLEY
value – press again to return to the Run Mode.
d
(ENTER)
• Press the enter
d
button to access the submenus from a Top Level
Menu item.
• Press
d
to store a submenu selection or after entering a value —
the display will flash a
STRD
message to confirm your selection.
• To reset flashing Peak or Valley press
d
.
• In the Run Mode, press
d
twice to enable Standby Mode with
flashing
STBY
.
Reset: Except for Alarms, modifying any settings of the menu
configuration will reset the device prior to resuming Run Mode.