Newport FSM-300, Руководство пользователя

Страница: 38 / 42

Appendices 38
7. Appendices
7.1 Appendix A – Troubleshooting the FSM System
Problem Possible Cause & Solution
Mirror does not respond to command
inputs. Green PWR indicator light is
off. Controller does not receive power. Assure that power plug is live,
that power switch is ON, and that fuses (located above power
connector) are good.
Mirror does not respond to command
inputs. Green PWR indicator light is
on. +5V is applied to the INT/EXT selector switch input (Pin 17),
causing the system to expect External Feedback inputs (Pins 11,
2, 15, 16). Or +5V is applied to Open Loop selector switch inputs
(Pins 9 or 10), causing the system to expect Open Loop inputs
(Pins 22, 24). Remove the +5V source or supply control voltages
on the required pins.
Yellow CURR indicator LED is on.
The drive signals to the mirror are
clipped. The attempt is made to apply to much RMS current to the FSM
drive coils, which would create a potential over-temperature
condition. Decrease amplitude and/or frequency of drive signal.
Red TEMP indicator LED is on.
Mirror does not respond at all. Thermistors have detected an over-temperature condition of the
drive coils because these are being driven too hard. Decrease
amplitude and/or frequency of drive signal. Also check for pos-
sible inverse polarity of an External feedback signal. System will
automatically resume normal operation once coils have cooled.
Mirror moves in opposite direction of
intended. Polarity is reversed at X and Y Command Inputs or X and Y
External Feedback Inputs. To remedy, reverse your electrical
connections, since the above four inputs are differential without
a fixed ground.