27-November-13 Phone: 1.800.325.7867 Fax: 1.636.925.0029 www.newcocoffee.com
5
Section 2
Set-Up Programming Instructions:
Open machine cabinet door and locate the 3-switch control panel w/lighted display screen. Three
dashed lines will appear on the display screen. As shown in figure 1.
Step 1. Enter a Programming Mode
Press and hold the center switch labeled “Enter”.
After five seconds, the display will flash “Flu”
approximately 13 times entering in to BIB tracking
mode. As shown figure 2.
Step 2. Enable/Disable BIB Tracking
This machine features the option to track the liquid output of a BIB and then alert the operator when
the BIB is empty. (Display will flash the pump number affected and buzzer will beep if enabled.)
To Enable BIB Tracking, use the
+
or
–
switch to scroll until the display reads YES. To disable BIB
Tracking, use the
+
or
–
switch to scroll until the display reads NO. As shown in figures 3 & 4. When
you have made your selection, press
“ Enter” to save and proceed to the next programming option. On or Off will appear on the display
screen. As shown in figure 5.
Fig. 1
Fig. 2
