27-November-13 Phone: 1.800.325.7867 Fax: 1.636.925.0029 www.newcocoffee.com
10
6. Press “Enter” to save and proceed with the set-up program. A
time value (min: sec) will appear in the display. If the switch that
you are programming has been set in a portion control mode,
the value will represent the current dispense time for the switch.
If the switch is in a continuous flow (push and hold) mode, the
time value will be 0:00 Shown in figure 13. To set portion
control, in this mode, use the + and – keys to enter the time of
dispensing.
7. Press “Enter” to save and proceed to the next set-up programming option. SEL will appear on the
display.
8. Continue with switch programming by repeating steps 1 thru 7.
9. When switch programming is completed, continue to press and release the “Enter” button until the
display returns to 3 dashed lines. The machine will be in a normal operating mode.
Procedure: Setting Portion Control in Normal Run Mode
To program a switch for portioned controls, in run mode, dispense time must start at “0:00" (see page
9 number 6) to do this:
1. Place the desired cup (or carafe) under the dispense head.
2. Press and hold the “Enter” switch.
3. Press and hold the selector switch that you want to program.
4. After two seconds release the “Enter” switch.
5. When the cup (or carafe) is filled to the desired level, release the selector switch. The switch is now
programmed to automatically fill to that level.
Procedure: Return Switch to Continuous Flow Mode
1. Push and hold the “Enter” switch for 8 seconds to enter a programming mode. The current
temperature setting will appear on the display. (Refer to: Page 3 Section 2 Step 1.)
2. Press and release the “Enter” switch until SEL appears on the display.
3. Press the selector switch that you want to return to continuous flow mode. (The switch identifier will
appear on the display.)
Fig 13