27-November-13 Phone: 1.800.325.7867 Fax: 1.636.925.0029 www.newcocoffee.com
12
Disconnect the BIB of sanitizing solution from the Pump 1 BIB connector and connect it to the Pump
2 connector.
Press the “Pump 2 (
–
) switch on the display panel to begin sanitizing.
When sanitizing cycle ends, remove the sanitizing solution and replace the products. The machine
will automatically advance to the Prime Pumps mode.
To Prime: Press and hold the “Pump 1” (
+
) switch until a steady stream of product flows from the
dispense area into the vessel.
Press the “Enter” switch to advance to Pump 2.
Press and hold the Pump 2 (
-
) switch until a steady stream of product flows into the vessel.
Press and release the “Enter Switch until 3 dashed lines appear in the display.
Discard the contents of the decanter or vessel.
Prime Pump Feature:
This feature allows you to enter directly into a Prime Pump mode without sanitizing.
Press the
-
switch to enter the Prime Pump mode.
Follow the same Prime Pump procedures from Sanitizing Instructions.
BIB Counter Auto-Reset Feature:
If enabled during the “Set-Up Programming” of the machine a buzzer alarm will sound once per
second to indicate that a product BIB is empty.
Entering into a Prime Pump mode turns off the alarm.
Only reset the pump shown on the display.
BIB tracking is automatically reset when the pump is primed.
Product Installation Procedures:
Open the cutout on the product box and position the BIB fitment into the
slotted area as shown in figure 1
.
Fig. 1
