27-November-13 Phone: 1.800.325.7867 Fax: 1.636.925.0029 www.newcocoffee.com
11
4. Press and release the settings “Enter” 3 times. (The selector switch timer will appear on the
display.)
5. Using the
+
and
–
switches, scroll until the selector switch timer reads 0:00
6. Press and release the “Enter” switch until 3 dashed lines appears on the display.
7. The switch is now in a continuous flow (push and hold) mode.
Procedure: Disable a Selector Switch
1. Enter program mode by pressing and holding the “Enter” switch for five seconds.
2. Press and release the “Enter” switch repeatedly until SEL appears in the display.
3. Press the selector switch that you have chosen to disable.
4. Press and release the “Enter” switch. Pump 1 speed will appear in the display.
5. Using the
+
or
–
button to scroll, set Pump 1 speed to 0.00
6. Press and release the “Enter” switch. Pump 2 speed will appear in the display.
7. Using the
+
or
–
button to scroll, set Pump 2 speed to 0.00
8. Press and release the “Enter” switch until thee dashed lines appear in the display. The switch is
disabled.
Section 3
Service Level Programming Functions:
Sanitizing Instructions
Press the
+
switch to enter sanitize mode. SAN will
appear in the display. (As shown in figure 14)
Remove the product BIBs from the machine and
connect a BIB of sanitizing solution to the PUMP 1 BIB
connector. (The one on the left (as you face the
machine from the front.)
Place an empty decanter or other vessel under the
dispense area of the machine.
Press the “Pump 1”
(+)
switch on the display panel to begin sanitizing.
When sanitizing cycle ends (2.5 minutes total: pump 45 sec., dwell 90 sec., & water 15 sec.), the
buzzer alarm will sound 3 times if enabled during the “Set-Up Programming”. The machine will
automatically advance to “Pump 2”. (Pump 2 will duplicate Pump 1’s process.)
Fig. 14
