New Leader Hi-Way SUPER P, Руководство оператора

Страница: 40 / 50

- 40 -
www.NewLeader.com
(800) 363-1771
301321-AA-I
SUPER P
General Operating Procedures Continued
Do not run engine in choke�
1� Place engine switch in “On” position�
2� Press top of throttle switch 5–10 seconds for choke� Note: If switch has LED indicator, light will illuminate
when unit is in choke�
3� Press engine “Start” until engine runs�
4� Press bottom of throttle switch to take engine out of choke� Note: If switch has LED indicator, light
turns off when unit is out of choke�
Electric Clutch Operation
1� Set throttle to a fast idle, engage clutch, and bring engine RPM up to spreading speed� The clutch
draws current only when engaged�
2� The clutch may be engaged or disengaged at any time� However, it is suggested that the clutch NOT
be engaged with the engine operating at high speed� Component damage may occur from excessive
shock loads to the system� Drive to the area to be spread�
3� Open the feedgate to give the desired amount of material� The unit will deliver one cubic foot per
minute at 3600 engine RPM with the feedgate open only 1/2” (13mm)� It will deliver at a rate of
6�3 cubic feet per minute with a 4-1/4” (108mm) feedgate opening at the same engine speed� The
delivery rate of material is determined by engine RPM and feedgate opening together�
4� Adjust engine throttle to desired speed and drive ahead�
5� When the pass is completed return engine to an idle� Disengage electric clutch�
Hydraulic Driven Units
1� Engage hydraulic pump� Allow system to run for several minutes to bring hydraulic oil up to
operating temperature�
2� When ready to spread, turn on the control valve� Set desired spinner and conveyor speed as
applicable�
3� Begin spreading�
4� Turn off control valve and disengage PTO when finished spreading.
System Operating Parameters
Operating pressure: 900 - 1200 PSI (62-82�75 bar)
Relief at: 1500 PSI (103�42 bar)
Flow, Single: 8�25 GPM (31�23 LPM)
Flow, Dual: 12 GPM (45�42 LPM)