New Leader Hi-Way SUPER P, Руководство оператора

Страница: 36 / 50

- 36 -
www.NewLeader.com
(800) 363-1771
301321-AA-I
SUPER P
Initial Start-Up Continued
Hydraulic Driven Units
1� Fill the hydraulic reservoir with oil. Refer to “Lubricant & Hydraulic Oil Specifications” section in this
manual for proper oil� Open gate valve fully (rotate counterclockwise to open)�
2� Be sure all bearings, shafts and gearcase are properly lubricated�
3� Check for proper alignment between spinner sprockets� Check to ensure sprocket set screws are
tightened sufficiently.
4� Start engine� Engage PTO or actuate electric clutch (if applicable)� Let engine run at about 1000 RPM
for several minutes, allowing hydraulic oil to reach operating temperature� Allow greater warm-up time
in colder weather�
5� Check for proper rotation of conveyor and spinner� The conveyor should move towards the rear�
The spinner should rotate clockwise when viewed from the top� If unit runs backwards, the hydraulic
system is assembled incorrectly� Shut unit down and determine problem� Correct the problem before
further operation. Check reservoir and refill as necessary after unit has been running long enough to
circulate oil through all lines�
Stay clear of spinner when it is operating� Contact with a moving spinner can cause
severe injury� Failure to comply with this requirement will result in death or serious injury�
6� Move hydraulic control valve to position 3� Conveyor and spinner should run at low speed� Allow to
run until they operate smoothly to indicate air has been purged from the system�
Do not check leaks with hands while system is operating as high pressure leaks can
be dangerous! If skin is pierced with hydraulic fluid at high pressure seek immediate
medical attention as fluid injected into the skin could cause gangrene if left untreated.
Relieve pressure before disconnecting hydraulic lines or working with system� Make
sure all hydraulic fluid connections are tight and all hydraulic hoses and lines are in good
condition before applying pressure to the system� Wear protective gloves and safety
glasses or goggles when working with hydraulic systems� Failure to comply with this
requirement will result in death or serious injury�
DO NOT check for hydraulic leaks adjacent to moving parts while system is operating
as there may be danger of entanglement! Failure to comply with this requirement could
result in death or serious injury�
7� Bring engine speed up (about 3000 RPM) and move hydraulic control valve to position 5� Run a few
minutes to be sure unit runs smoothly� Shut the system down� When all parts have come to rest, check
all hydraulic system connections for leaks�
8� Check hydraulic oil level� Add oil as necessary� For units with NLM-supplied hydraulic reservoirs, oil
should be visible in the bottom of the strainer basket when the reservoir cap is removed� Unit is now
ready for road testing�