New Leader Hi-Way SUPER P, Руководство оператора

Страница: 16 / 50

- 16 -
www.NewLeader.com
(800) 363-1771
301321-AA-I
SUPER P
HIGH PRESSURE FLUID HAZARDS
Figure 3.7 - Escaping fluid under pressure can penetrate the skin
causing serious injury�
Always stop machine, allow to cool and relieve pressure before
servicing hydraulic system� Never open hydraulic lines under pressure�
Make sure all connections are tight and all hoses are in good
condition before pressurizing system�
Always use a piece of cardboard or wood to search for leaks instead
of hand� Wear impervious gloves and eye protection when servicing
system�
Seek medical attention immediately if fluid penetrates your skin.
Gangrene may result if wound is left untreated�
Figure 3�7
AVOID HEATING NEAR HIGH PRESSURE FLUID LINES
Figure 3�8 - Flammable spray can be generated by heating near
pressurized fluid lines, resulting in burns to yourself and bystanders.
Do not heat by welding, soldering or using a torch near pressurized
fluid lines or other flammable materials.
Pressure lines can suddenly burst when heat goes beyond the
immediate flame area.
Figure 3�8
AVOID TOXIC FUMES & DUST
Figure 3�9 - Hazardous fumes can be generated when paint is heated
from welding, soldering or using a torch�
Remove paint before heating:
• Remove a minimum of 4 in (100 mm) from area to be affected by
heating� If paint cannot be removed, wear an approved respirator
while heating or welding�
• Avoid breathing dust from sanding or grinding on paint�
• If a solvent or paint stripper is used, wash stripper away with
soap and water before heating or welding� Remove solvent or
paint stripper containers and other flammable material from area.
Allow fumes to disperse for at least 15 minutes before heating or
welding�
Do not use chlorinated solvents in areas where welding will take
place�
Perform all work in a well-ventilated area that will carry all toxic fumes
and dust away�
Figure 3�9
Maintenance
General Safety Rules