12
９
９
．
．
H
H
o
o
w
w
t
t
o
o
r
r
e
e
m
m
o
o
v
v
e
e
a
a
n
n
d
d
i
i
n
n
s
s
t
t
a
a
l
l
l
l
a
a
d
d
i
i
e
e
b
b
l
l
o
o
c
c
k
k
■
Following is t
he procedure to remove and install a die block.
※
Note
: Be sure to turn off the power and unplug the power plug from the outlet before attempting repairs.
TOOLS NEEDED
：
Phillips screwdriver.
6 mm L shape hexagonal wrench (
Allen wrench) located in the accessory bag.
1. Remove the right and left side 4pcs screw
⑩
of top cover
③
of main unit.
2. Please pull it up and remove the top cover
③
and put it aside as the following picture.
※
It is better not to remove the top cover’s connector of the main body.
3. Remove the die block fixing screw
⑪
with the enclosed
Allen wrench.
4. Slowly
pull on the die block and remove it.
※
When the shaft pin
⑯
is disengaged from the arm
⑮
of the mai
n body the di
e block punching part will go down.
5. Disconnect the 2 positions of the connector
⑭
of the depth gauge switch
⑫
.
6. Pull the shaft pin
⑯
out of the die block.
7. Prepare the new die block
⑦
for replacement.
8 . Insert the shaft pin
⑯
into the new die block.
9. Place the die block
⑦
on the die base
⑰
and connect the depth gauge switch
⑭
firmly.
10. Pull up the shaft pin
⑯
, insert it into the arm, push the die block
⑦
all the way in.
※
The groove on the back of the die block is inserted into the stud bolt
⑬
on the main body side.
11. Attach the die block with the screw
⑪
and
firmly tighten
.
12. Insert the top cover
⑨
into the body from the upward direction.
※
Please push the connector downward so that the connector will not protrude.
13. Tighten the top cover screws firmly.
14. The die block replacement is now completed.
