11
８
８
.
.
D
D
e
e
p
p
t
t
h
h
A
A
d
d
j
j
u
u
s
s
t
t
m
m
e
e
n
n
t
t
s
s
■
There is a microswitch to auto-activate the perforation cycle located on the depth gauge.
(Upon paper insertion, the machine will activate automatically)
※
The position of the micro switch is set at the point of
maximum depth
when shipped from the factory.
■
If you need to change the depth, please adjust according to the following procedure.
※
The microswitch is located on the depth gauge located on the right side of the die block.
Note
: Please turn off the power when you adjust the depth.
Do not attempt to adjust the depth switch gauge on the left side of the die block if the power is on.
1. To adjust the depth position, please loosen the screw
⑫
and change the depth position by sliding the gauge
either forward or backward.
2. First adjust the right side depth gauge and then adjust the left side depth gauge.
Key points of the adjustment: To check whether the position of the depth gauge is equal on both the
left and right side, insert one piece of paper and check th
e squareness of th
e paper.
3. After the adjustments are made, please turn on the power switch
①
and make a perforating test.
Check the
positioning of the perforation and make final adjustments as necessary.
Left depth gauge
Right depth gauge
