17
Model:
Netti 4U BASE
Language:
English
Version:
2022-03
My-Netti.com
• The wheelchair is set to a standard seat depth,
and the plastic bracket has 4 holes of which three
are temporarily blocked with plastic plugs
• The back rest hinge has 4 holes. The hole
positions are in accordance with the holes in
the plastic bracket. If the locking head of the
gas spring is mounted in the inner hole of the
plastic bracket, the back rest hinge should also be
mounted in the inner hole etc.
• Find the required position for the locking head in
the plastic bracket, and remove the plastic plug
from this hole.
• Lock the back rest by pushing the locking bolt
through the plastic bracket and the gas spring
locking head.
• After changing the hole position in the plastic
bracket, the hole position in the back rest hinge
must be changed into the parallell position.
Check that the hole in the back rest hinge
and the plastic bracket are mounted into the
same hole position.
6 mm Allen-key.
6.5 BACKREST
• To mount the gas spring, lift the push bow with
one hand, and lead the gas spring locking head
into the plastic bracket with the other.
• If the gas spring seems to be too long it must be
compressed. Press the horizontal lower back tube
towards the end of the gas spring while you pull
the handle for the back recline. The gas spring will
be compressed and fit into the plastic bracket.
• Check that the hole in the locking head is parallell
with the open holes in the plastic bracket.
• Lock the backrest by pushing the locking bolt
through the plastic bracket and gas spring
locking head
To check that the back rest is locked, grip
the push bow and press the back rest
forward.
If the back rest falls forward – repeat the
locking procedure or contact your local
dealer.