Advanced Settings
110
N300 Wireless Router WNR2000v4
IPv6 6to4 Tunnel
To set up an IPv6 Internet connection by using a 6to4 tunnel:
1.
Select
Advanced > Advanced Setup > IPv6
.
The IPv6 screen displays.
2.
Select
6to4 Tunnel
from the menu.
The screen adjusts:
The information in the following fields is automatically detected by the router:
•
Router’s IPv6 Address on WAN
. This field shows the IPv6 address that is acquired
for the router’s WAN (or Internet) interface. The number after the slash (/) is the length
of the prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
•
Router’s IPv6 Address on LAN
. This field shows the IPv6 address that is acquired
for the router’s LAN interface. The number after the slash (/) is the length of the prefix,
which is also indicated by the underline (_) under the IPv6 address. If no address is
acquired, the field displays Not Available.
3.
Configure the remote 6to4 relay router settings by selecting one of the following radio
buttons:
•
Auto
. Your router uses any remote relay router that is available on the Internet.
This is the default setting.
•
Static IP Address
. Enter the static IPv4 address of the remote relay router.
This address is usually provided by your IPv6 ISP.