NETGEAR WG103 ProSafe, Справочное руководство

Страница: 91 / 120

WG103 ProSafe 802.11g Wireless Access Point Reference Manual
Troubleshooting 6-3
v1.0, February 2009
The Test LED Remains Amber
There is a system fault or a firmware upgrade failure.
• Reload or upgrade the firmware (see “Upgrading the Wireless Access Point Firmware” on
page 4-5 ).
• Contact NETGEAR if the Test LED remains amber after you have upgraded the firmware.
You Cannot Access the Internet or the LAN from a
Wireless-Capable Computer
There is a configuration problem. Check the following:
• You may not have restarted the computer with the wireless adapter to allow TCP/IP changes
take effect. Restart the computer.
• The computer with the wireless adapter may not have the correct TCP/IP settings to
communicate with the network. Restart the computer and check that TCP/IP is set up properly
for that network. The usual setting for Windows the Network Properties
is set to “Obtain an IP
address automatically.”
• The wireless access point’s default values may not work with your network. Check the
wireless access point default configuration against the configuration of other devices in your
network.
• Make sure that the SSID, network authentication, and data encryption settings of the computer
with the wireless adapter are same as those of the wireless access point.
• Ping the IP address of the wireless access point to verify that there is a wireless connection
between the computer with the wireless adapter and the wireless access point. If the ping fails,
check the network configuration.
• Ping the default gateway to verify that there is a path from the computer with the wireless
adapter to the default gateway. If the ping fails, check the network configuration or call the
Internet service provider (ISP).