NETGEAR WG103 ProSafe, Справочное руководство

Страница: 83 / 120

WG103 ProSafe 802.11g Wireless Access Point Reference Manual
Advanced Configuration 5-11
v1.0, February 2009
2. Configure the other wireless access point (AP2 on LAN Segment 2 in Figure 5-7 on page
5-10 ) in point-to-point bridge mode.
AP1 must have AP2’s MAC address in its Remote MAC Address field and AP2 must have
AP1’s MAC address in its Remote MAC Address field.
3. Configure and verify the following for both wireless access points:
• Verify the LAN network configuration of the wireless access points. Both must be
configured to operate in the same LAN network address range as the LAN devices.
• Both wireless access points must use the same ESSID, channel, authentication mode, and
security settings.
4. Verify connectivity across LAN 1 and LAN 2.
A computer on either LAN segment should be able to connect to the Internet or share files and
printers of any other computers or servers connected to LAN Segment 1 or LAN Segment 2.
How Configure Point to Multi-Point Bridge Mode
Set up a point to multi-point (P2MP) bridge only if the wireless access point (the WG103) is the
“master” for a group of bridge-mode wireless access points. Then all traffic is sent to this “master,”
rather than to the other wireless access points. Up to four profiles can be configured.
The following figure shows an example of a point to multi-point bridge mode configuration.
Figure 5-8