NETGEAR FS700TS, Руководство по администрированию программного обеспечения

Страница: 133 / 190

FS700TS Smart Switch Software Administration Manual
Managing Security 6-5
v1.0, September 2007
If default values are not defined, the system defaults are applied to the new new
servers.
To configure Settings:
1. Click Security > Management Security > . The screen displays:
The screen contains the following fields:
• Host IP Address – Enter the Server IP address.
• Key String – Enter the default authentication and encryption key for
communication between the device and the server.
• Authentication Port – Enter the port number via which the session occurs.
The default port is port 49.
• Timeout for Reply – Enter the amount of time (in seconds) the device waits for an answer
from the server before retrying the query, or switching to the next server.
Possible field values are 1-30. The default value is 5.
• Single Connection – Select whether a single open connection between the host
Authentication Port and the server is enabled or disabled. The possible field
values are:
– Enable – Enable a single connection.
– Disable – Disable a single connection.
• Active – Select whether this server is the primary or backup server used for
authentication. The possible values are:
– Primary – Define the Primary Server.
– Backup – Define the Backup Server.
2. Select the server entry.
Figure 6-3