NetApp StorageGRID Webscale 10.4, Руководство по установке и обслуживанию

Страница: 34 / 68

b. Enter a new name for the controller, and click OK.
Related information
NetApp Documentation: SANtricity Storage Manager
Configuring the E5600SG controller management port
Management port 1 on the E5600SG controller connects the controller to the Admin network for
StorageGRID Webscale. You can configure this port using a web browser on the service laptop.
Additionally, you should enter the subnet mask for the network and at least a default gateway.
Before you begin
• You must have a service laptop with a web browser already installed.
Note:
Mozilla Firefox is the recommended browser for this task.
About this task
If management port 1 and the 10-GbE optical ports 2 and 4 on the E5600SG controller are connected
to networks with DHCP servers, and the controller includes version 1.5 or later of the StorageGRID
Webscale Appliance Installer, the controller attempts to obtain dynamically assigned IP addresses
when you power on the enclosure. After the controller has completed the power-on process, its seven-
segment display shows HO, followed by a repeating sequence of two digits.
HO -- IP address for Admin network -- IP address for Grid network HO
In the sequence:
• The first set of numbers is the DHCP-assigned IP address for management port 1 on the E5600SG
controller (if available). This address is used to connect to the Admin network for StorageGRID
Webscale.
• The second set of numbers is the DHCP-assigned IP address used to connect the appliance to the
Grid network for StorageGRID Webscale.
Note: If an IP address could not be assigned using DHCP, 0.0.0.0 is displayed.
Your network administrator can also use the controller's MAC address to look up the dynamically
assigned IP address for the controller's management port. The MAC address is printed on a label on
the back of the E5600SG controller (adjacent to the port).
Note:
If the E5600SG controller includes an earlier version of the StorageGRID Webscale
Appliance Installer, the display shows IM. Earlier versions of the StorageGRID Webscale
Appliance Installer do not support the use of DHCP IP addresses.
While the DHCP-assigned addresses allow you to access the E5600SG controller initially, you must
follow the steps in this section to configure static IP addresses for all E5600SG controller interfaces.
You must also follow these steps if you have version 1.3 of the StorageGRID Webscale Appliance
Installer.
Attention:
To ensure that you do not lose access to the StorageGRID Webscale appliance, NetApp
strongly recommends that you set a static IP address for all E5600SG controller interfaces. A static
IP is required for VMware-based grids.
Steps
1. Access the E5600SG controller with the service laptop.
34 | StorageGRID Webscale 10.4 Appliance Installation and Maintenance Guide