5. In the Out-of-band management box , enter one of the following values:
•
Using DHCP: The IP address assigned by the DHCP server to management port 1 on the
E2700 controller
•
Not using DHCP:
192.168.129.101
Note:
Because you are currently configuring only the E2700 controller, enter only one
controller IP address.
6. Click Add.
7. Continue with configuring the management ports.
Related information
NetApp Documentation: SANtricity Storage Manager
Configuring the E2700 controller management port
You can use SANtricity Storage Manager on the service laptop to set the IP address for the E2700
controller management port. If you accessed the E2700 controller using an IP address obtained using
DHCP, you must follow these steps to set a static IP address.
Before you begin
You must have a service laptop with SANtricity Storage Manager already installed.
About this task
For detailed instructions, see the SANtricity Storage Manager documentation.
Attention:
To ensure that you do not lose your management connection to the hardware and the
controller firmware in the StorageGRID Webscale appliance, NetApp strongly recommends that
you set a static IP address for E2700 controller by following the steps in this section.
Steps
1. From SANtricity Storage Manager, click the Devices tab.
2. In the Devices tab, double-click the newly added array.
32 | StorageGRID Webscale 10.4 Appliance Installation and Maintenance Guide
Содержание StorageGRID Webscale 10.4
Страница 2: ......
