Neo-Pure PRO-41000-A Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 7 / 20

Installation Guide 6/29/2023 7
Permeate Pump Installation
1. It may be necessary to trim tubing to ensure
a proper fit of pump in the bracket with out
ports on top.
2. The permeate pump snaps into the black
mounting clip already assembled to the
bottom of the mounting bracket between the
pre and post filter housings. (#3 above)
Orient the pump so the OUT ports are at the
top (12:00) after the pump is snapped into
the bracket.
3. Locate the blue tubing hanging between the
housings that is attached to the ASO (Auto
Shut
- Off) Push the stem elbow on the other
end into the PERMEATE OUT port. The other
blue tube will connect to the PERMEATE IN
port
4. Locate the red tubing hanging between the
two housings that is connected to the
membrane housing and flow restrictor. This
connects to the BRINE IN port. Once the air
gap faucet is installed, the red
1/4” tube from
the faucet air gap attaches to the BRINE OUT
port.
#3
Permeate Pump
Auto Shut - Off
To Air Gap
Flow
Restrictor
OUT
IN
Mounting Clip
Outlet Elbow Assembly
The post filter outlet requires the stem adapter and elbow be installed.
These parts are in the install kit bag to avoid shipping damage.
1. Apply 3 - 4 wraps of Teflon tape to the threaded end of the stem adapter
and screw into the threaded port of the post filter be carful to not over
tighten.
2. Once the stem adapter is securely in place, push the elbow onto the stem
so the collet is all the way down on the stem