User Manual of E Series Network Speed Dome
53
schedule configuration is the same as the settings of the arming schedule for motion
detection. Refer to
Section
5.2.1 Configuring Motion Detection
.
8.
Click
tab to select the linkage method taken for the video loss alarm,
Notify surveillance center, send email, upload to FTP, trigger channel, smart tracking and
trigger alarm output are selectable. Refer to
Section
5.2.1 Configuring Motion Detection
.
9.
Click
to save the settings
5.3.6
Region Exiting Detection
Purpose:
Region exiting detection function detects people, vehicle or other objects which exit from a
pre-defined virtual region, and some certain actions can be taken when the alarm is triggered.
Steps:
1.
Enter the Region Exiting Detection settings interface:
Configuration> Event > Smart Event> Region Exiting Detection
2.
Check the checkbox of
Enable
to enable the Region Exiting Detection function.
Figure 5-25
Configuring Region Exiting Detection
3.
Select the region from the dropdown list for detection settings.
4.
Click the
button to start the region drawing.
5.
Click on the live video to specify the four vertexes of the detection region, and right click to
complete drawing.
Repeat the step to configure other regions. Up to 4 regions can be set. You can click the
button to clear all pre-defined regions.
6.
Set the detection target for the region entrance detection.
You can select human, vehicle, or
all (human &vehicle) as the detection target from the dropdown list. If Human is selected,
