Wall Mount the Xn120 system
10
Xn120 Getting Started Guide
2
Remove the sub cover of the
Xn120.
Hook the Xn120 onto the wall
mount screws.
Tighten the lower screws to
secure the unit to the wall.
3
Earth the Xn120 system.
Caution:
If this cable is not
installed or requires
disconnection, then the
telecommunication network
connection(s), CO and/or
ISDN, must be disconnected
first from the Xn120.
Important.
The system must have a permanent Earth Ground
connection to a verified Earth point using a minimum of 2.5mm
2
green/yellow cable.
The Earth connection must have no other purpose than connecting to
the Xn120 unit.
The Earth point is located
on the left side under the
sub cover.
Push
Slide
Hook
onto
screws
Fasten lower
two screws
