45
Setting Up Your Projector
1
Remove the side cover.
Side cover of the projector should be removed to mount the option board. For the procedure of removing the side cover,
refer to “1-5-2. Removing and Mounting the Side Cover” (page 28).
2
Remove the blocking panel from slot.
1.
Loosen the knurled screws (2 places) of slot until their rotations become idle ( ). Screws
cannot be removed.
2. Remove the blocking panel ( ).
Slot
GP I/O
3D
RS-232
USB
REMOTE
LAN
NOTE
Carefully store the blocking panel and screws that you removed.
3
Mount the option board to the projector.
1.
Insert the board by following the guide on either side of the slot.
2. Tighten up the knurled screws (2 places) until it fix.
guide (left/right)
4
Mount the side cover to the projector.
This completes the mounting of option board. Next, recover the tamper error. For the procedure of recovering, refer to “3-2. Recov-
ering from Tamper Errors” (page 49). A setting to use option board is needed, after recovering from tamper error. For the proce-
dure, refer to “2-7-1. Make the option board usable” (page 46).
