NEC N8151-32B, Руководство пользователя

Страница: 62 / 92

54
Installing the Built-in DVD-RAM Drive into 5.25-inch Device Bay
Install the Built-in DVD-RAM drive into the computer.
WARNING
Do not disassemble, repair, or alter the Built-in DVD-RAM drive.
Never attempt to disassemble, repair, or alter the Built-in DVD-RAM drive on any
occasion other than described in this User's Guide or the manual of the computer in
which the Built-in DVD-RAM drive is installed if you are not a maintenance engineer.
Failure to follow this instruction may cause an electric shock or a fire as well as
malfunctions of the Built-in DVD-RAM drive.
Do not install or uninstall the Built-in DVD-RAM drive while the power cord of
the computer is connected to the AC inlet.
Turn off the power of the computer and unplug the power cord from the AC inlet
before installing/uninstalling the Built-in DVD-RAM drive to/from the computer. If the
power is turned off but the power cord remains inserted to the AC inlet, certain
current flows in the computer. Having your body touch parts in the Built-in DVD-RAM
drive in such condition may cause an electric shock.
CAUTION
Hot surface
Immediately after the computer is powered off, its internal components such as hard
disk drives are very hot. Leave the computer until its internal components fully cool
down before installing/removing any component.
•
Connect the Built-in DVD-RAM drive to the bus to which the factory installed CD-
ROM/RW drive is also connected. Connect the IDE interface cable coming with the
Built-in DVD-RAM drive to the device bay adjacent to the CD-ROM/RW drive
because the MASTER-to-SLAVE cable only has a rather short length.
•
Some computers can be equipped with the Built-in DVD-RAM drive vertically. In the
installation, the Built-in DVD-RAM drive cannot accept 8-cm CD. To use 8-cm CD,
install the Built-in DVD-RAM drive horizontally.
Install the Built-in DVD-RAM drive in the device bay to be adjacent to the factory
installed CD-ROM/RW drive. In addition, connect the interface cable to the proper
connector on the motherboard, the Built-in DVD-RAM drive, and the CD-ROM/RW
drive in the order. Then it may become necessary to change the installation slots of
some devices already installed (see the figure on the next page).