![background image](http://html.mh-extra.com/html/nec/express5800-120rf-1/express5800-120rf-1_user-manual_251202142.webp)
4-46 Configuring Your Server
RAID Configuration by Array Configuration Utility (ACU)
This section describes how to configure the RAID by using the "Array Configuration Utility
(ACU)" that can be called from POST.
NOTE:
You can configure the RAID drive by using Express Setup of
NEC EXPRESSBUILDER. See Chapter 6 for details.
Running the Array Configuration Utility (ACU)
To start ACU:
NOTES:
Make sure that the BIOS has been changed according to "Enabling
RAID Feature by BIOS SETUP Utility".
To start the ACU from management PC via serial (direct)
connection or via network, see also "NEC EXPRESSBUILDER" in
Chapter 6.
1.
Start the server.
2.
To run ACU, press
Ctrl
+
A
when prompted by the following message during the system
startup:
Press <Ctrl><A> for Adaptec RAID Configuration Utility
NOTE:
If it takes a long time until a message appears on the display
unit, press
Ctrl
+
A
three to five seconds after power-on.
After a while, the ACU menu appears.
To change or delete RAID configuration
To perform low-level formatting or verification of RAID drive
Содержание Express5800/120Rf-1
