![background image](http://html.mh-extra.com/html/nec/express5800-120rf-1/express5800-120rf-1_user-manual_251202304.webp)
9-18 Upgrading Your Server
Server (Pull-out from the Rack)
The server needs to be pulled out from the rack for installing/removing any components other than
the hard disk drives and power supply units.
CAUTION
Observe the following instructions to use the server safely. Failure to follow
these instructions may result in death or serious personal injury. See pages 1-3
to 1-8 for details.
Do not install the server on a rack with leaving covers removed.
Do not pinch your finger with mechanical components.
Note high temperature.
Do not pull out a device from the rack if the rack is unstable.
Do not leave more than one device being pulled out from the rack.
1.
See the section "Preparing for Installation and Removal" described earlier to prepare.
NOTE:
To confirm the device you are going to maintain, use the UID
switch and the UID LED that goes on when the switch is pressed.
2.
Loosen the thumb screws at the right and left of the front panel, hold the handles, and
slowly pull out the server from the rack.
The server is locked while you are pulling it. Stop pulling when it is locked.
Captive thumb screws
Содержание Express5800/120Rf-1
