Nebu-tec SaHoMa-II HM-2000-1, Инструкция по эксплуатации

Страница: 13 / 33

20 21
The nebulization process runs continuously and as long as there is inhalation solution in the medication
chamber of the SaHoMa®-II mesh nebulization unit.
If the inhalation solution has been completely nebulized, the aerosol production stops. The SaHoMa®-II control
unit indicates the end of the inhalation process by two light bars that run synchronously from the center to
the right and left.
After some time the SaHoMa®-II control unit switches off automatically. The SaHoMa®-II control unit can also be
switched off manually by shortly pressing the button.
Attention
A SaHoMa®-II mesh nebulization unit must always be connected. Otherwise, the SaHoMa®-II control unit
will display an error image. For more information on error images, please refer to chapter 6.3 „Self-help:
Troubleshooting“.
Caution
To activate the automatic switch-off, the SaHoMa®-II control unit needs to run for at least two minutes.
3.3. Switching on the SaHoMa®-II control unit in program 2
Start the SaHoMa®-II control unit by pressing and holding the button through the side opening in the
SaHoMa®-II protection cover.
Hold the button of the SaHoMa®-II control unit until the nebulization process starts and then a red light bar
appears in the first field of the display.
You can now set the desired time in five-minute intervals, with one bar corresponding to a nebulization time
of approx. five minutes.
3| Performing and ending the inhalation process Performing and ending the inhalation process |3
Press
& hold