NDS ConductOR, Руководство пользователя

Страница: 52 / 66

45
Demonstraton Program
The included Demonstration program (NDS 58D0023) is intended for demonstration, installation
and testing of the
ConductOR . It may not be used in an OR while any clinical procedure is in
progress.
Setup:
1. Connect a straight through serial cable (NDS 35D0003 or equivalent) from the PC’s serial port to the
RS-232 IN connector.
2. Connect one or more signal sources to the appropriate inputs.
3. Connect one of the outputs to a compatible monitor.
4. The
ConductOR and the PC should be turned on.
Usage:
The demonstration program is designed to run on a 1280 x 1024 or larger monitor.
Click the Windows Start button, then click All Programs. Select: NDS Surgical Imaging, then select and click
DemoOR-G2 to launch the demonstration program. The program’s startup screen is shown below. The
four right hand primary / secondary input labels will be blank until the program is communicating with the
ConductOR .
Click the green button in the lower right corner to start communications with the
ConductOR .
The
Com Port and Address selection windows are displayed.
Select the
Com Port using the + or - buttons to the right of the Com Port window.
If the address isn’t 0, then set it to 0 using the
+ or - buttons to the right of the Address window.
After selecting the
Com Port and Address click the Accept Selections button.
Continued on the following page.