NDS ConductOR, Руководство пользователя

Страница: 36 / 66

29
Note: The IP addresses that appear in the screen shots on this and following pages are for illustration only.
Location to Location Transmit Setup
Launch the ConfigOR-G2 program, the program’s startup screen should look like the left screen shot
below. A Not Connected message will be shown in its lower left corner
Click the pull down arrow on the right side of the COM Port window and select the COM port to be
used. Finally, click the Connect button.
A successful connection will ‘gray out’ the
Connect button, fill in the IP Address, Subnet Mask and
Gateway windows. A dot appears in the radio button to the left of “Use the following static IP address”.
The message in the lower left corner will change to: Connected . Close the ConfigOR-G2 program.
Click the radio button to the left of “
Obtain an IP address automatically… .”. You may manually assign
the IP Address, Subnet Mask And Gateway by clicking the radio button to the left of “ Use the following
static IP address ” and entering the required information. Finally, click the Connect button.
Location to Location Receive is described on the following page.