NCT Group 100T, Руководство оператора

Страница: 113 / 144

13.5 Automatic Mode Restart with BLOCK RETURN Condition
113
13.5.3 Cases of Return by Means of Condition BLOCK RETURN
Cases of return by means of BLOCK RETURN condition correspond to that of BLOCK
RESTART condition, except for return is made not to start position of block, but to the
interruption point.
Return to Interruption Point after Interrupting Simple Movement Block
1
st
case: in state G40 interrupting and restarting linear interpolation
The diagram shows the case,
when a linear interpolation in the
plane X, Z is interrupted, a
manual mode is set and manual
operation is used along the two
axes. If after all the automatic
mode is returned and after
switching the BLOCK RETURN
condition on the START
button is pressed or manual
operation is used in one of the
manual modes when the BLOCK
RETURN condition is on,
the control goes to the interruption point of the block.
In the return process all axes take part , even those not programmed in the interrupted
block.
If on an axis the
compensation is modi-
fied, as for example
along axis X on the dia-
gram beside, or a work
zero point offset is
changed it returns to X
position valid on the
interruption point of the
block registering the
new compensation or
offset.
Return to Interruption Point after Interrupting Canned Cycles
Let us examine the following canned cycle:
...
G17 G90 G81 X100 Y70 Z–60 R2 F200
...