NCT Group 100T, Руководство оператора

Страница: 136 / 144

14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
136
3073 NOT EXISTING PRO-
GRAM NO. If, in case of subprogram call (M98 P) or
macro call (G65 or G66 or G66.1 P),
the program number specified at address P
is not in the memory,
subprogram or macro call has been se-
lected for G, M, A, B, C, S, T and the re-
ferring subprogram is not in the memory,
or
the program executor called the subprogr-
am or macro, which is being edited at the
moment (EDIT screen). The message is can-
celed by RESET
key.
3074 ODD G67 If a modal macro end function is found
(G67), the pair of which does not exist
(G66, G66 1). The message is can-
celed by RESET
key.
3075
DEFINITION ERROR N If the value of block number (N) is greater
than 16000000. The message is can-
celed by RESET
key.
3076
NO END OF PROGRAM If the program end is not defined by
means of commands M2, M30, M99 or %. The message is can-
celed by RESET
key.
3077
3078
3079
3080
ERRONEOUS USE OF # Reference is made to a non-existing macro
variable (#...), or
to - in the given block - forbidden macro
variable (#...). The message is can-
celed by RESET
key.
3081 DEFINITION ERROR ,C ,R When programming chamfering or corner
round in the block containing ,C or ,R or
in the following block no coordinate in the
selected plane has been programmed. The message is can-
celed by RESET
key.
3082
NO RETURN M99 No return (M99) was programmed at the
end of a subprogram or a macro program. The message is can-
celed by RESET
key.
3083 R=0 If the start or end point radius is 0 in a
programmed arc. The message is can-
celed by RESET
key.
3084 ,C ,R TOO HIGH OR FOR-
BIDDEN If an impossible chamfering (,C) or corner
round (,R) has been programmed. The message is can-
celed by RESET
key.
3085 CIRCLE ERROR G51 If scaling is programmed (G51 X Y Z I J
K) and in circular interpolation different
rates of scaling are on the different axes. The message is can-
celed by RESET
key.